
General Specifications Genesys? 750W/1500W
2.1 INPUT CHARACTERISTICS
1. Input voltage/freq. (*1)
2. Power Factor
3. EN61000-3-2,3 compliance
85~265Vac continuous, 47~63Hz, single phase
0.99 @100/200Vac, rated output power.
Complies with EN61000-3-2 class A and EN61000-3-3 at 20~100% output power.
4. Input current 100/200Vac
5. Inrush current 100/200Vac
750W :10.5A / 5A,
750W :Less than 25A,
1500W :21A / 11A
1500W :Less than 50A
6. Hold-up time
2.2 POWER SUPPLY CONFIGURATION
1. Parallel Operation
2. Series Operation
2.3 ENVIRONMENTAL CONDITIONS
1. Operating temp
2. Storage temp
3. Operating humidity
4. Storage humidity
5. Vibration
6. Shock
7. Altitude
2.4 EMC
1.Applicable Standards:
2.ESD
3.Fast transients
4.Surge immunity
5.Conducted immunity
6.Radiated immunity
7.Conducted emission
8.Radiated emission
9.Voltage dips
10. Conducted emission
11. Radiated emission
2.5 SAFETY
1.Applicable standards:
2.Withstand voltage
3.Insulation resistance
2.6 MECHANICAL CONSTRUCTION
1. Cooling
2. Dimensions (WxHxD)
More than 20mS , 100Vac , at 100% load.
Up to 4 units in master/slave mode with single wire current balance connection
Up to 2 units. with external diodes. 600V Max to Chassis ground
0~ 50°C , 100% load.
-20~ 70°C
30~90% RH (non-condensing).
10~95% RH (non-condensing).
MIL-810E, method 514.4 , test cond. I-3.3.1. The EUT is fixed to the vibrating surface.
Less than 20G , half sine , 11mSec. Unit is unpacked.
Operating: 10000ft (3000m), Derat output current by 2%/100m abouve 2000m, Non operating: 40000ft (12000m).
IEC1000-4-2. Air-disch.-8KV, contact disch.-4KV
IEC1000-4-4. 2KV
IEC1000-4-5. 1KV line to line, 2KV line to ground
IEC1000-4-6, 3V
IEC1000-4-3, 3V/m
EN55022B,FCC part 15J-B, VCCI-B.
EN55022A,FCC part 15-A, VCCI-A.
EN61000-4-11
EN55022B, FCC part 15-B, VCCI-B.
EN55022A, FCC part 15-A, VCCI-A.
CE Mark, UL60950,EN60950 listed. Vout<60V:Output is SELV , IEEE/Isolated analog are SELV.
60<Vout<400V: Output is hazardous, IEEE/Isolated analog are SELV.
400<Vout<600V:Output is hazardous, IEEE/Isolated analog are not SELV.
Vout<60V models :Input-Outputs (SELV): 3.0KVrms 1min, Input-Ground: 2.0KVrms 1min.
60<Vout<600V models: Input-Haz. Output: 2.5KVrms 1min, Input-SELV: 3KVrms 1min.
Hazardous Output.-SELV: 1.9KVrms 1min, Hazardous Output-Ground:1.9KVrms 1min.
Input-Ground: 2KVrms 1min.
More than 100Mohm at 25°C , 70% RH, 500Vdc
Forced air flow: from front to rear. No ventilation holes at the top or bottom of the chassis; Variable fan speed.
W: 422.8mm, H: 43.6mm, D: 432.8mm (excluding connectors, encoders, handles, etc.)
3. Weight
4. AC Input connector
750W : 7Kg (15 Lbs)
750W: IEC320 AC Inlet.
1500W : 8.5Kg (18 Lbs)
1500W: Screw terminal block, Phoenix P/N: FRONT-4-H-7.62 , with strain relief
5.Output connectors
2.7 RELIABILITY SPECS
1. Warranty
6V to 60V models: Bus-bars (hole ? 8.5mm). 80V to 600V models: wire clamp connector , Phoenix P/N: FRONT-4-H-7.62
5 years.
*1: For cases where conformance to various safety standards (UL, IEC etc.) is required, to be described as 100-240Vac (50/60Hz).
All specifications subject to change without notice.
Outline Drawing Genesys? 750W/1500W Units
NOTE
1. Bus bars for 6v to 60v models (shown)
Wire clamp connector for 80V to 600V models
2. Plug connectors included with the power supply
3. Chassis slides mounting holes #10-32 marked "A"
GENERAL DEVICES P/N : C-300-S-116 or equivalent
|4